1/1/2024 0 Comments Instal the new CyVenge![]() Get a friend to assist here, get one to hold the brake / caliper assembly and the other jump in the boot and remove the final thread on the top of the control arm while you hold the strut assembly. Using your hammer and a screwdriver remove the lower bolt.ħ. Using the breaker bar, loosen the bolt on the lower control arm and remove the nut completely, TIP:You will need the assistance of a hammer to help knock the bolt thru. Remove the wheel and place them under the sill in case the car falls / slipped off the stand.Ħ. Start by raising the car up off the ground and getting jack stands under the car, NEVER work on a car with just a car jack supporting it.Ģ. In hindsight I should have taken measurements from ground to top of guard so I could record how much I dropped it, but alas I didn't.ĭISCLAIMER : I don't take any responsibility for any damage / loss that my occur from performing this modification.ġ. Please be aware this is not the only way and everyone else will do it differently, please use this as a guide and not gospel on how it should be done.īefore doing this I watched a heap of Youtube videos and also looked at the suspension and how it all went together and worked. Finally got my coil overs installed and set to the height that I want, and as promised here it my HOW TO do it, now I have not taken photos of all the steps but I will try and explain in as much detail where I can
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |